CLO ヘルプセンター
anooshehka
- 合計アクティビティ 6
- フォロー 0ユーザー
- フォロワー 0ユーザー
- 前回のアクティビティ
- 投票 0
- サブスクリプション 1
- メンバー登録日
アクティビティの概要
anooshehkaさんの最近のアクティビティ-
anooshehkaさんがコメントを作成しました:
Hi CLO Designers, My AI file is in inches and I have setup CLO in inches as well. When I import it says inches. So I am not sure if the pattern is imported correctly. Would you mind sharing a mini ...
-
anooshehkaさんがコメントを作成しました:
I just dids ome calculations and realized that eventhough it is showing 100% scale but it enlarges my pattern by 2540%! same as the person above! There is something wrong with Clo. Can you advise w...
-
anooshehkaさんがコメントを作成しました:
This is at 20% scale
-
anooshehkaさんがコメントを作成しました:
And what is worse is that the scale of it is so high that Clo crashes! and when I enter 1% it shrinks the pattern. When I put 100% it enlarges it perhaps by 100 times and then 3D model disappears a...
-
anooshehkaさんがコメントを作成しました:
Hi I have the same problem! The setting is based on inches and my file is based on inches and the % is 100% but when I import it, the pattern gets 100 times bigger!