D-ring(OBJ from CLO) the fabric doesn't stay behind ring

Follow

rachelxchuang

• 2020年03月17日 12:31

Hi, 

I made a sliding D-ring on CLO, and save as OBJ, following instruction on this Youtube video (https://www.youtube.com/watch?v=vNClfQfz7Yk)

1. I use the Select Mesh tool to pull out the fabric.

 

However, as soon as i stimulate, the fabric goes back to as before and does not stay between the ring. 

 

> Is this a problem cause of the "Skin Offset", which i could not find in my property editor. 

 

0

• danielemanassero

  • 2020年03月17日 13:26

  Hi rachelxchuang, if you have imported the obj as an avatar click on the buckle and the property editor panel will show up.

  To stay in place the pieces need some thickness and a PD of 5. 

  First keep the thikness collisin od the pieces of fabric 3 or for only when it is in place start to lower this value and the skin offset too a little.

  You can also import the obj as a trim and then glue it to the fabric.

  Daniele

  1
• rachelxchuang

  • 2020年03月18日 05:56

  Hi Daniele, 

  Thanks for your answer! It worked after i imported as Avator instead of Trim!

   

  0

サインインしてコメントを残してください。