How to make lower hem straight

Follow

Sadi

• 2019年10月30日 06:39

0

• vadsura

  • 2019年10月30日 11:42

  To leave the frozen bottom layer, or use a rigid fabric for the first layer.

  https://www.clo3d.com/clollab/artwork/2705

  1
• ottoline

  • 2019年10月30日 20:18
  • 編集済み

  On the lower hem patterns if you place in a stiff tape the edges will stiffen and won't be so prone to pulling up. You can also change the sewing seam type angle of these two pattern pieces at the hem, so that they are at a more acute angle and you can raise the strength so they sit firmly together (that appears to be the single biggest issue causing the fault). You should also do that with the sleeve ends as well.

   

  All my quilt pattern edges have tape and then the sewing angle is checked to make sure the type > angle > strength pulls the edges nice and straight.

   

  

   

  

  Sewing custom angle > seam line fold angle

  

  Added in 20mm edge seam tape > rolling fold angle changes the edge performance.

   

  TIP > change your simulation mode to > Simulate (Complete Non Linear)

  0
• Sadi

  • 2019年11月02日 07:20

  THNK YOU SO MUCH

  0

サインインしてコメントを残してください。