(Fabric kit) Exception in Bending Test
[If the tip of the fabric falls into a diagonal line]
When the end of the fabric falls into a diagonal line, measure the end nearest to zero.
[ If the fabric is bent inwards]
If the end of the fabric bends inwards, rotate it back and measure the length when the end of the fabric meets the ground at 90 degrees.
[ If the fabric bends outwards ]
When the fabric bends outwards, measure the Contact Distance where the fabric touches the ground.
When measuring Length, measure the same point used to measure the Contact Distance.
[ If the tip of the fabric sticks to the machine and falls off]
(Solution)
-
Turn the lever to pull out half of the fabric.
- Turn the lever in the opposite direction to insert the fabric. Continue turning until the end of the fabric meets the ground at 90 degrees. Then, measure the Length.
0
コメント