メインコンテンツへスキップ

CLO ヘルプセンター

どのようなご用件でしょうか?

コメント

  • CLO Designers

    Hi andreiaandrade,

    To check the fit properly, can you set the avatar's Skin Offset to 0 and the Add'l Thickness Collision of the pattern pieces to 1 and simulate again? All of these are air buffers around the respective components that will influence the visual outcome.

    0
  • dorelle22

    andreiaandrade you can try to keep the sleeves on different layer until you set your pose. Also keep the sleeve mesh higher density just by a few. Meaning if the body particle distance is 8 then the sleeve can be 5

    0
サインインしてコメントを残してください。