Rendering problem for fur and some similar fabrics

Follow

herinhr

• 2022年11月20日 05:23

Sometimes the rendering just keeps going on even if the rendering time is limited to 6min and minimum. The rendering just never stops. Last time it was nearly 15+hrs which i left it overnight and it never rendered a single image. It was turn table image and even the noise was 0.0010 which is quite good. I'm not sure what's the issue here.

0

• CLO Designers

  • 2022年11月21日 14:40

  For fur have you changed your render engine from GPU to CPU? CPU will run better for fur. For noise we recommend increasing slightly to 0.010

  Also for fur 6 minutes is quite a short amount of time. You may need to increase depending on your computer specs. You can check our recommended specs HERE

  0

サインインしてコメントを残してください。