CLO Centre d'aide
jne4sl
- Activité totale 103
- Abonné à 0 utilisateur
- Abonnés 0 utilisateur
- Dernière activité
- Votes 11
- Abonnements 38
- Membre depuis
Commentaires
Activité récente par jne4sl-
Thanks, that's what had happened. The back side was activated but no changes had been made. I guess it was really the simulation image that confused me, it was showing opacity on the back side th...
-
There was a recent thread pointing out the same problem (maybe it was also your question). When down grading there's a logic error of some sort, a change in the x-axis value causes the y-axis valu...
-
I agree with Pablo Quintana the normals aren't "partially flipped" it is that the layers are intersecting, and this does only become an issue when layers are thick, but I find it's good practice w...
-
Hmm. On the pocket bag, the bit of fold at the top edge hasn't been sewn. Sew those two bits of bag together turned and layer to back. After your previous problem, did you re-drape the bag and s...
-
Yes, layer clone is good, but I'm usually working with an existing pattern, and I'd like to use it as-is whenever possible. Sewing lines default to "Front", which is why many people only layer thi...
-
In hand drafting this would be a compass construction, that's why I asked if you where sure the line could span, you aren't just looking to move the line, but to find out where it intersects the ot...
-
Starting again. The "All" option works fine, never mind that comment. Arrow key grading works fine, but when down grading, the logic reverses, which makes sense. This seems to be a problem when d...
-
I was just doing this and running into the same thing. Grading down, seems to cause problems. At best the logic seems to be reversed, and whenever there's an automatic calculation points don't mov...
-
You can view the grain line while adding an internal line. Draw a line along the grain line as best you can and then rotate using that. Or for your specific pattern, the bottom of the outseam and...
-
Yes. I'm getting the same thing. I was able to launch and use the beta for several days, but as of Oct. 19, I get this message. Also the online contact forms are not working on the website. I ge...