CLO Centre d'aide
Jodi
- Activité totale 11
- Abonné à 0 utilisateur
- Abonnés 0 utilisateur
- Dernière activité
- Votes 0
- Abonnements 3
- Membre depuis
Aperçu des activités
Dernière activité effectuée par Jodi-
Jodi a créé une publication,
Hi, I'm changing the size of my avatar - all the measurement adjustments are fine, apart from the arm. If I try to adjust the arm length even a little bit, it crumples the avatar up. Currently the ...
-
Jodi a ajouté un commentaire,
Thanks for replying so quickly, sorry ignore .avs comment - all understood! On the avatar it's the faceless Connect avatar named FV2.1 Mannequin.avt - I've switched to the new CLO library and I've ...
-
Jodi a créé une publication,
Hi, I'm having issues with opening avatars in version 2024.2.160 I want to open the CLO-SET CONNECT faceless avatar(pic attached) - it says this file format is not supported in this version? Is thi...
-
Jodi a ajouté un commentaire,
Ok, thank you very much!
-
Jodi a ajouté un commentaire,
no it doesn't change at all and it isn't my file actually. Maybe the grade file doesn't actually have data then! I can't open it to check though, I think it's a Gerber file. Can I stitch the garmen...
-
Jodi a ajouté un commentaire,
Thanks for the quick reply! I've just done that, but still I can't see anything and nothing changes.
-
Jodi a ajouté un commentaire,
-
Jodi a créé une publication,
Hi, I've imported a .DXF pattern into Clo - in the same folder I have the .RUL file. Named exactly the same, apart from the end file format. But I can't see the grading in the 2D window - there is...