CLO Centro de Ayuda
Trademark993
- Actividad total 19
- Siguiendo 0 usuarios
- Lo siguen 0 usuarios
- Última actividad
- Votos 0
- Suscripciones 5
- Miembro desde
Comentarios
Actividad reciente de Trademark993-
Yeah I'm working on an older Mac... How much RAM do you think is needed to have the program run smoothly?
-
isabelcrosby2 Thank you again!
-
pabloquintana Perfect! Thank you! As for the simulation, its off but whenever I make any changes, it still takes 5-10 seconds per change that I make and I'll get a screen like this
-
@isabelcrosby2 @PabloQuintana This is my first 3D program and this is my first month with the program after being trained TUKA. I'm fresh out of college, I'm a real beginner but I know this progra...
-
pabloquintana Thank you for your response and sorry for my vague question. I was raising the hem of this pant block to turn into shorts. I raised it 15 inches initially by grabbing the bottom seg...
-
isabelcrosby2 Yeah I basically drew these lines with a mixture of add point and I believe the internal polygon tool. I'm trying to raise the hem of my pant block to make shorts. What I did was brin...
-
Wow Otto, thank you for your input. Its a lot to take it to be honest and I'm sorry for not replying to this sooner. I'm reading this over this a few times to fully process what you're saying. From...
-
It did and thank you!
-
Hey Pablo, I really appreciate the comment! What I'm trying to do is align a graphic over a pattern and print it directly to the fabric to cut it out. I like your method, although the graphic is pl...