Thanks for advice.  I am using the binding tool and I don't see a layer property for the binding. I tried changing the layer property  on the actual pattern piece, but it didn't make a different.  ...

• Ver comentario
• marin.millar
• 30 de diciembre de 2020 09:10
• 0 votos

Thank you for the advice.  This helped a lot.  

• Ver comentario
• marin.millar
• 23 de diciembre de 2020 13:30
• 0 votos

Thank you for your help.  I did the test and here are the results: Yes, for my project the particle distance is 20mm on each piece and it should be at human scale.  Just one thing to confirm..I sh...

• Ver comentario
• marin.millar
• 21 de diciembre de 2020 17:27
• 0 votos

How can we switch back to 5.2?  My performance is so poor that I cannot even complete the simplest of actions.  

• Ver comentario
• marin.millar
• 21 de diciembre de 2020 08:48
• 0 votos

Hello, I have followed the recommendations in this post and the reference posts, but my performance is still very slow.  It's so slow that I can't even complete my project, which is urgent.  Every ...

• Ver comentario
• marin.millar
• 21 de diciembre de 2020 08:43
• 0 votos

Thank you very much!  I was alway adding zippers using the zipper tool in the 3D window and it was very difficult sometimes.  This tip is really helpful. 

• Ver comentario
• marin.millar
• 12 de diciembre de 2019 17:38
• 0 votos

Thank you Daniele.

• Ver comentario
• marin.millar
• 4 de diciembre de 2019 13:00
• 0 votos

Nevermind...I found the grainline property in the Properties window.  Thanks!

• Ver comentario
• marin.millar
• 4 de diciembre de 2019 09:09
• 0 votos