CLO Centro de Ayuda
CLO Centro de Ayuda
allyshake hizo un comentario,
I am delighted you were able to incorporate my suggested improvement and you even used my diagram. It is gratifying when a sw developer does this. Unfortunately my old trial expired of Clo 4.0 a lo...
allyshake hizo un comentario,
@goddessofpizza thanks heaps. So am I right in saying the simulation and drape is effected when you put the grain line of the texture on the 45 deg? It looks like it does. I am thinking of bias cut...
allyshake hizo un comentario,
Brilliant, the video is very helpful, thanks.
allyshake hizo un comentario,
Oh silly me! I had a fabric applied but no texture. I wanted to see the simulation effects of moving the grain line to the bias direction of the fabric. I am assuming it should stretch more along t...
allyshake creó una publicación,
I am trying to select this mode from the top right hand corner but it appears to be greyed out. Is this because I only have the trial?
allyshake creó una publicación,
I have been experimenting with the binding tool but noticed that it only binds between seam lines and not over them, (see photo). When finishing a corset a long piece of binding, (which may be bias...
allyshake hizo un comentario,
@Anh thanks. That is really interesting about the Bonding. As mentioned above, I have been experimenting using the Attach to Avatar Tape to keep panels in place on the avatar whilst I drape and loo...
allyshake hizo un comentario,
It would be really useful if there was a Convert Line (Avatar) to Avatar Tape tool. That way you could exactly match the lines drawn for the pattern pieces before flattening and then use the Attach...
allyshake hizo un comentario,
I have been using this technique but not achieved the thickness @geniusbutton did. What fabric did you use? Also it would be really useful if there was a Convert Line (Avatar) to Avatar Tape tool. ...
allyshake hizo un comentario,
Found an answer to the straight edges question above. New in Clo 4.1 is Edit Line (Avatar) tool, select line, right click and pop up menu now includes option for Flattening as Straight Line. Not su...