CLO Centro de Ayuda
danijel100
- Actividad total 16
- Siguiendo 0 usuarios
- Lo siguen 0 usuarios
- Última actividad
- Votos 3
- Suscripciones 5
- Miembro desde
Resumen de la actividad
Última actividad de danijel100-
danijel100 hizo un comentario,
Thank you so much! I was also wondering why for some reason when pattern is not even applied on avatar or used in simulation I still have the different length for 2D and 3D?
-
danijel100 creó una publicación,
Hi there, how would you approach excluding yellowed segment? I usually duplicate the whole garment and then use cut; but are there any other way of doing these since that approach kind of slowdown...
-
danijel100 creó una publicación,
Hi there, what is the difference between the 2D and 3D length? I have my armhole selected and I am not sure which measure I should use? Thanks in advance!
-
danijel100 creó una publicación,
Hi, how should I approach zipper modeling if I want this kind of zipper collar (as in attached picture). When I make just a cut in a fabric my zipper gets twisted in the end. Should I make a recta...
-
danijel100 creó una publicación,
Hi there, as the title says how to select one part (arm) of the avatar? I one to hide/deactivate just one arm but when I click to hide it program automatically selects both arms. xx
-
danijel100 hizo un comentario,
Hi there, it's so much better. It seems like I pushed the fold to far. But still can there is a small puff, you can see it by the picture - is there a way to make it completely flat like it's pres...
-
danijel100 hizo un comentario,
If I am not wrong there already is an internal line? Photo included.
-
danijel100 creó una publicación,
Hi there, I am wondering why my neckband/hem goes this puffy? I dropped particle distance to 5, thickness is 0. The hem is folded edge and the neckband is two piece pattern segment. Please let me...