[If the tip of the fabric falls into a diagonal line]

When the end of the fabric falls into a diagonal line, measure the end nearest to zero.

[ If the fabric is bent inwards]

If the end of the fabric bends inwards, rotate it back and measure the length when the end of the fabric meets the ground at 90 degrees.

[ If the fabric bends outwards ]

When the fabric bends outwards, measure the Contact Distance where the fabric touches the ground.

When measuring Length, measure the same point used to measure the Contact Distance.

[ If the tip of the fabric sticks to the machine and falls off]

  (Solution)

1. Turn the lever to pull out half of the fabric.

   
   

2. Turn the lever in the opposite direction to insert the fabric. Continue turning until the end of the fabric meets the ground at 90 degrees. Then, measure the Length.