Saltar al contenido principal

CLO Centro de Ayuda

¿Cómo podemos ayudarte?


Adding a print to a full width roll


  • CLO Designers

    Hi timbutler,

    Set the Texture to 140cm in the PE:

    Open the Print Layout, set roll width to 140cm, and let nesting run, your pattern piece will snap to the outermost corner and be filled completely.

    (I tested this with changing from Repeat to Unified for the Texture, but didn't achieve the desired result. So this one here requires a few steps, but brings perfect outcome.)

Iniciar sesión para dejar un comentario.