CLO Help Center
- Total activity 142
- Following 1 user
- Followed by 1 user
- Last activity
- Votes 1
- Subscriptions 44
- Member since
Comments
Recent activity by mail-
I know. But was not my exact question, but I figured out myself. Via Annotation [A], I can delete old pattern names, which may have been imported with the DXF. Thank you.
-
How do I make sure that no pressure is applied to any pattern?
-
Hi. I would also like to know where to get a handbook to learn about all that properties above. My silk jersey is also bouncing insanely, while animation mode and simulation.
-
Ahh, that was helpful, I added it now. I'll check tomorrow if it became more reliable. Thank you
-
Thank you. As I said before, the second window does not appear like that here at my PC.
-
Hi. Unfortunately, it was necessary because the seam allowance outwards (look) always collapse behind the shell fabric, what they were not meant to do. They were supposed to be on top, what they de...
-
I know that. But see it as a conversation starter. I want that your support contacts me, and then we see how we address the problem together. I am fed up to dig around in the dark. Furthermore, I a...
-
When one longer sup-panel fluently runs over several pattern pieces. How do I apply than with that technique. It seems to be an issue. Before with layering: Waiting Since hours, just getting worst ...
-
Okay Thanx. I try that. It is not necessarily a sublayer, it is just a volant inserted in the seams. And I of course use no wind-machine the fabric is just super bouncy, against all logic and gravity.
-
Thank you, I try that than. Trying to solve that unpleasant CLO3d workflow on my own starts to become a main job.