CLO Help Center
CLO Designers
Admin- Total activity 4384
- Following 0 users
- Followed by 3 users
- Last activity
- Votes 62
- Subscriptions 1868
- Member since
Comments
Recent activity by CLO Designers-
Hi biztory2, Unfortunately, the other user never came back with the info we asked for, so there hasn't been any development. Could you provide us with an example where the fabric is so thick that t...
-
Hi c8719ece7dbb449e6a46, Could you please share a screenshot of your own window where it doesn't work?
-
Hi sxdy, In what capacity? Do you mean stacking them on a specific point in the 2d layout?
-
Hi domenicdbr, - Have you tried the Fabric Creator? It was added in 7.3. You can input the information your have about your fabric (e.g. composition) and it will generate a fabric for you. https://...
-
Hi sonja, Do you mean in the main menu? The options are showing fine for me. If you do not mean the main menu, could you take a screenshot of where what you're looking for is missing?
-
Hi mlmgrn, The topstitches are sitting exactly on an internal line which can cause this effect. Change the offset of the topstitches to just a hair more or less, e.g. 2.1 or 1.9 instead of 2mm. Thi...
-
Hi sigridfinne, Does your computer fit the hardware recommendations? https://support.clo3d.com/hc/en-us/articles/115000307168-CLO-system-requirements-June-2024 Could you please screenshot the error...
-
Hi cac4cd707728f468cba9, Use the Edit Pattern tool, select the dots (you can also pull a selection box across several at once), right-click on them and choose "Convert to Curve Point". This convers...
-
Hi tiinab, Could you try this workaround and see if it helps? Load the file in CLO, save it as an AVT (File --> Save As --> Avatar). Then use this AVT when converting. It can help with smoother res...
-
Hi there, what do you mean by the outer layer sticking to the inner layer? They are sewn onto each other and then Pressure applied as far as I can see (upper layer and lower value should have the s...