Marine

  • Total activity 21
  • Following 0 users
  • Followed by 0 users
  • Last activity
  • Votes 3
  • Subscriptions 6
  • Member since

Activity overview

Latest activity by Marine

  • Marine commented,

    1. Community
    2. Q&A
    3. Binding disappears in simulation and rendering

    Thanks for advice.  I am using the binding tool and I don't see a layer property for the binding. I tried changing the layer property  on the actual pattern piece, but it didn't make a different.  ...

  • Marine created a post,

    1. Community
    2. Q&A

    Binding disappears in simulation and rendering

    Hello, I have binding on an armhole and a neckline.  The neckline binding shows correctly, and some of the armhole binding shows, but sometimes it disappears after simulation   The binding type is ...

    • Marine
    • 3 followers
    • 3 comments
    • 0 votes

  • Marine commented,

    1. Community
    2. Q&A
    3. Slow Performance even with strong PC.

    Thank you for the advice.  This helped a lot.  

  • Marine commented,

    1. Community
    2. Q&A
    3. Slow Performance even with strong PC.

    Thank you for your help.  I did the test and here are the results: Yes, for my project the particle distance is 20mm on each piece and it should be at human scale.  Just one thing to confirm..I sh...

  • Marine commented,

    1. Community
    2. Q&A
    3. Clo v6 performance vs v5.2

    How can we switch back to 5.2?  My performance is so poor that I cannot even complete the simplest of actions.  

  • Marine commented,

    1. Community
    2. Q&A
    3. Slow Performance even with strong PC.

    Hello, I have followed the recommendations in this post and the reference posts, but my performance is still very slow.  It's so slow that I can't even complete my project, which is urgent.  Every ...

  • Marine created a post,

    1. Community
    2. Q&A

    Error Replacing Pattern Outline

    Hello, I copied a line from one pattern piece and pasted to another.  Now I want to replace one pattern line with the copied line.  However, when I use the Replace Pattern Outline command, I get an...

    • Marine
    • 1 follower
    • 0 comments
    • 0 votes

  • Marine commented,

    1. Community
    2. Q&A
    3. Creating Zippers at Underarm

    Thank you very much!  I was alway adding zippers using the zipper tool in the 3D window and it was very difficult sometimes.  This tip is really helpful. 

  • Marine created a post,

    1. Community
    2. Q&A

    Creating Zippers at Underarm

    Hello,  Does anyone have any tips on creating zippers in difficult places?  I am trying to create a zipper in the underarm for a ski jacket, and I also tried to created a zipper at the inner thigh ...

    • Marine
    • 2 followers
    • 2 comments
    • 0 votes

  • Marine commented,

    1. Community
    2. Q&A
    3. How to change the grainline direction on a 2D Pattern piece

    Thank you Daniele.