Attach a zippuller on the CLO zipper made with the Zipper tool

Follow

claudiobrunotti56

• May 30, 2021 08:05

Hi, 

I can make a zippulle with a brand name in clo3D and exporting as OBJ, then importing back and glue it on the puller of the Zipper made with the "Zipper Tool".

All ok but when I change pose or make animations the puller do not move with the garment and stay in the same position....

I will like to know How can attach a zippuller that stay on the CLO3D puller made with CLO "Zipper TOOL"

 

I will apreciate any help

Thanks

Claudio

0

• pablo.quintana

  • May 31, 2021 16:56

  Why don't you use a strip of fabric as the zipper tape. That way any trim can be glued onto that strip of fabric.

  0
• claudiobrunotti56

  • May 31, 2021 19:39

  Hi Pablo,

   

  Thanks for your suggestion.

  I know that will be one good solution but will not allow to open and close the zip when i need to do so.

   

  0
• pablo.quintana

  • May 31, 2021 21:34

  Sure you can. You just need to split the strip in the middle and sew or un sew to open or close it.

  0
• claudiobrunotti56

  • May 31, 2021 23:10

  Hi Pablo thanks again, I understand , I thought that was possible using the Zipper tool, it would make it easier and faster.

  thanks

  Claudio

  0

Please sign in to leave a comment.