SHERPA RENDER ISSUES
Dear CLO design team,
I have a problem rendering with sherpa. The lining of the hood should have a sherpa optic and the outer hood in
Knitt. Unfortunately both fabrics mix when rendering.
I used the settings shown below.
May you give me a hint to make it look clean.
Thanks a lot
0
-
Official comment
designhamburg Working with fur/sherpas can be a bit tricky. If this is a two sided fabric, you will have to adjust the thickness of the fabric and the height of the sherpa or the sherpa will appear to push through the other side. If you create two fabrics in your Object Browser that you modify, you can use them to make one two-sided fabric that will work.
-
Many many thanks for you help. This is a very good suggestion!
0
Comments