how to make a drawstring in clo?
I would like to create a rounded long drawstring. similar to the image below. I have used a slim, rectangular fabric piece to lace a pair of pants, however I do not like the tedious twisted result. Is there a solution?
-
Official comment
willemjan Hi. Do you have your fabric surface on Thick Textured Surface in the 3D toggle menu?
-
0 -
vadsura this is perfect! how did you get this result for the drawstring? I can inly seem to get the image on the right.
0 -
You just need to add the thickness of the fabric. 2 mm strip, set the thickness to 5 mm for this pattern or another, which you like best
0 -
vadsura I raised the thickness to 5mm, and its thicker but still square, I am not sure why the edge is black either,
how is yours rounded? 0 -
strip width 2mm render thickness (3D view 5 mm or more) Now you have the other way around. strip width 5 mm and render thickness 2 mm. Just experiment with the thickness until the strip becomes round.
0 -
I trie, but nothing happens. What can be wrong?
0 -
Make sure you are in Thick Textured Surface.
0 -
That was the problem, thanks!
0
Comments