Pressing pattern piece and its facing flat
Dear Community,
some time ago I asked how to sew and arrange a lapel and its facing. Your tips with layer clone under or superimpose under worked well and
there are no problems with the stability of the blazer in general! :) Thanks for that.
But unfortunately, I can't press the lapel and its facing flat. During the draping process everything lies flat (see pic 1) and shortly after draping is finished "it blows itself up" (see picture two, I hope one can recognize it). I followed your tips and worked with Reduced Collision Thickness, Bonding and Strengthening but it doesn't help. I also lowered the Particle Distance it doesn't make any difference. Does anyone have any idea why?
Best regards
ifashion
Pic 1
Pic 2
-
If you are sure that the Add'l collision is low (maybe 0.1 or 0.2) check two things:
1. Does any one of the pieces have Pressure beyond or below zero?
2. Is the Sewing Line Type Turned?
0 -
Ah, there was some pressure on the pattern pieces! I overlooked that. Thank you so much for your help Pablo, it worked out now!! :)
0 -
Hi there. I sewed a lot of jackets in the clo and nothing exploded. So I don’t know a specific solution. Try to exclude the collar from the simulation and simulate without it, then the problem will show itself. Maybe this collar creates tension.
0 -
In order to know how to fix fit problems on a blazer, it is advisable to have experience working with a specific client in the studio. Not with computer patterns, with living people, with real fabrics.
Obviously the problem is in this seam. You need to pull the collar along the line of percogne, perhaps you need to strengthen the lapel
0 -
Yes, deactivate Pattern and Sewing is also good to know for collar simulation. But in my case the problem really was the pressure on the pattern piece.
I think when to be able to make a proper fitting blazer, other projects will be easier in CLO. So definitely I will come back with some blazer questions to you ;-)
0
Comments