Custom/manual seam allowance intersection/angle

Follow

ashleykirk

• March 21, 2023 01:06

Hi,

I am making a bodice and have set the seam allowances to .5". Even after changing the seam allowance intersection, there is still an overhang of seam allowance. How can I adjust the seam allowance intersection/angle so that the sewing lines perfectly match up when the pieces are sewn together? See attached screenshot. Thank you!

0

• CLO Designers

  • March 21, 2023 10:13

  Dear ashleykirk, the different shapes are a result of the blunter and sharper angles on both pattern pieces.

  This will also happen when drafting on paper by hand, but can then be leveled out – in CLO it is a limitation that it is not possible, unfortunately.

  0

Please sign in to leave a comment.