Rendering problem for fur and some similar fabrics
Sometimes the rendering just keeps going on even if the rendering time is limited to 6min and minimum. The rendering just never stops. Last time it was nearly 15+hrs which i left it overnight and it never rendered a single image. It was turn table image and even the noise was 0.0010 which is quite good. I'm not sure what's the issue here.
0
-
For fur have you changed your render engine from GPU to CPU? CPU will run better for fur. For noise we recommend increasing slightly to 0.010
Also for fur 6 minutes is quite a short amount of time. You may need to increase depending on your computer specs. You can check our recommended specs HERE
0
Comments