Unable to visualise pattern in Print Layout mode
I have just subscribed to CLO3D, and cannot seem to use the print layout mode- or more precisely I cannot see my pattern pieces when I do. The Propoerty editor states that the pattern pieces have been laid out, but the whole pattern side of the screen remains grey.
I have used the print layout mode in the trial version of CLO3D, so i dont understand what is not working now. I have tried closing the program and reopening, but no luck.
Any ideas?
Thanks a bundle
-
Hi. When you go from trial to subscription everything should stay the same. Which version of CLO are you currently using?
Also your screen shot is so small it is hard to see what is happening.
If the error persists you can always uninstall CLO and the re install
0 -
Hi,
I have same problem here, and I uninstalled and after installed again but nothing changed.
Can you help me ?0 -
Hi zeynepcevik
Is this happening just on this file or on all CLO files? If you just load in the CLO default tee does Print layout work?
If it is happening for all filles please reach out to us through our Contact Us Page HERE and include 1 of the affected files for us to test.
0 -
Hi, in the end I had to scrap my project because all the other CLO files worked- the patterns I made from scratch, but the one that I had built basing it on the default tee would not allow me to print the pattern, not even after resinstalling several times.
I assumed then it was because you couldn't print the default clothing?
is that correct?
Thanks, Anna
0 -
Hi artlass
There should be no issue with using the CLO default tee in Print layout. see below screenshot. Besides your earlier post did you reach out directly to our Tech Support on CLO3d.com? As this was several months ago and you did not respond back to this post we may have thought this issue was resolved. There may have been a bug, which is now resolved
0 -
Hi I just want to confirm that this is still any issue. I'm using 7.3 and have this problem today US Designer Support
0 -
Sharing the solution here for any future users. The Fabric was changed from Fabric to Elastic in the Property Editor and since Elastic is Not cut from rolls the pattern pieces did not appear in Print Layout
0
Comments