CLO HELP CENTER

How can we help you?

Select Binding

Follow

Objective 

Edit Binding Properties.


Location

Main Menu ▶ Materials ▶ Binding ▶ Select Binding

3D Toolbar ▶ Select Binding 

※Note: 3D toolbar ▶ Select bindings with the Select/Move tool. 


Operation

  1. Select the tool/menu indicated.
    → The line segment for which the binding was created is displayed. 
      
  2. Select the Binding to be edited. 
    → Its properties appear in the Property Editor.  
      
  3. Configure each property as needed referring to below table.
    Option
    Description
    Name Rename Binding's name.
    Line Length Check Binding's length. However, it cannot be changed from the Property Editor.
    Type
    Under Bindings are placed under the Patterns to express Inside Bindings.
    Over
    Bindings are placed over the Patterns.
    Both
    (ver 7.0)
    Bindings are placed both direction of the Patterns.

    Dimension

    Width

    Adjust selected Binding's width. (1~50mm)

    Length

    Adjust selected Binding's length with percentage (50% ~ 200%) or a specific value.
    Particle Distance Edit selected Binding's Particle Distance (4~20mm)
    Add'l Thickness -  Collision Adjust Binding's Add'l Thickness - Collision.

    Fabric

    Assign Fabric to the Binding. 
    Fabric styles in the Fabric Object Browser appear in a list.
    Grain Direction

    Bias/

    Warp/ Custom

    Choose among Bias, Warp, or Custom for the Binding's grain direction.
    Angle Manually insert Angle value to set the Binding's grain direction.

    Topstitch

    Add Topstitch to the Binding.

    The Topstitch option shows the styles which are added in the Topstitch tab of Object Browser.

    Sewing Line Type

    Edit Binding's Sewing Line Type.
    Extend

    Set whether to extend the binding after creating it on a part of the line segment.
    ※ Note: Binding Extension is not possible in the following cases.

     When the angle of both segments are more than 180 degrees based on the binding start/end point.

      
  4. Right-click on the Binding to be edited.
    Option
    Description
    Delete   Delete selected Binding.
    Reset Arrangement

      Reset Binding's position.
      Use this option to fix unstable simulations.

    Deactivate / Activate   Deactivate or activate selected Binding.
    Freeze / Unfreeze   Freeze or unfreeze selected Binding.
    Flip Normal
      The selected Binding's face flips to the other side.

Was this article helpful?
6 out of 9 found this helpful

Comments

Please sign in to leave a comment.