Edit Binding Properties.
Main Menu ▶ Materials ▶ Binding ▶ Select Binding
3D Toolbar ▶ Select Binding
※Note: 3D toolbar ▶ Select bindings with the Select/Move tool.
- Select the tool/menu indicated.
→ The line segment for which the binding was created is displayed.
- Select the Binding to be edited.
→ Its properties appear in the Property Editor.
- Configure each property as needed referring to below table.
Name Rename Binding's name. Line Length Check Binding's length. However, it cannot be changed from the Property Editor. Type Under Bindings are placed under the Patterns to express Inside Bindings. Over Bindings are placed over the Patterns. Both
Bindings are placed both direction of the Patterns.
Adjust selected Binding's width. (1~50mm)
Adjust selected Binding's length with percentage (50% ~ 200%) or a specific value. Particle Distance Edit selected Binding's Particle Distance (4~20mm) Add'l Thickness - Collision Adjust Binding's Add'l Thickness - Collision.
Assign Fabric to the Binding.
Fabric styles in the Fabric Object Browser appear in a list.
Choose among Bias, Warp, or Custom for the Binding's grain direction. Angle Manually insert Angle value to set the Binding's grain direction.
Add Topstitch to the Binding.
The Topstitch option shows the styles which are added in the Topstitch tab of Object Browser.
Edit Binding's Sewing Line Type. Extend
Set whether to extend the binding after creating it on a part of the line segment.
※ Note: Binding Extension is not possible in the following cases.
When the angle of both segments are more than 180 degrees based on the binding start/end point.
- Right-click on the Binding to be edited.
Delete Delete selected Binding. Reset Arrangement
Reset Binding's position.
Use this option to fix unstable simulations.
Deactivate / Activate Deactivate or activate selected Binding. Freeze / Unfreeze Freeze or unfreeze selected Binding. Flip Normal The selected Binding's face flips to the other side.