CLO HELP CENTER

How can we help you?

Change Length

Follow

Change Length

- Change the length of a segment towards the start, end, or both directions.

- Select the  Edit Pattern tool.  Navigate to the 2D window, right click on a segment to be edited and select Change Length. The Change Length window will appear.

- Select and modify below settings as needed.

    • Start

      Follow the instruction above to open the Change Length Window.

      - For Location, select Start. Then, type in the desired value to Length.

      - The start point of the selected segment will be adjusted based on the designated length value.

    • End

      - Follow the instruction above to open the Change Length window.

      - For Location, select End. Then, type in the desired value to Length.

      - The end point of the selected segment will be adjusted based on the designated length value.

    • Both

      - Follow the instruction above to open the Change Length window.

      -  For Location, select Both. Then, type in the desired value to Length.

      - Both start and end points of the selected segment will be equally adjusted based on the designated length value.
Was this article helpful?
0 out of 0 found this helpful

Comments

Please sign in to leave a comment.