Objective
Modify the Zipper Slider and Stopper (ver 5.2) properties.
Location
3D Toolbar ▶ 
Select/Move
Operation
- Select the tool indicated in Location.
-
Select a Zipper or Stopper created on a 3D Garment and modify its properties:
Option
Description
Name
Name the zipper.
Shape
Slider
Select a shape for the slider.
Puller
Select a shape for the puller.
Stopper
(ver 5.2)Select the Stopper type (Open / Closed End) and then select shapes for Top and Bottom.
※ Note: A selection of Bottom shapes is configured based on the shape of the Stopper.Specification
Gauge Select the size of the Slider by Gauge or percentage. Weight (g)
Assign the weight of the slider. (ver 4.2)
Fasten Zipper
Reverse Zip Direction
Select the zip direction. The slider is relocated based on the option.
Move to Opposite Side
Select a side of the zipper tape where the slider will locate when the zipper is open.
Material
Configure the Slider's Type, Texture, Color, and Opacity.
※ Note: Uncheck Use Same Material as Slider after selecting the Puller or Stopper tab to assign material separately. (ver 5.2)
Hi
I did not understand the meaning of " Diffuse Map ". You can explain more about it.
Thanks