Objective
Export patterns as a DXF file from Gerber in order to use them in CLO.
Operation
- Load the pattern to be exported, and click File ▶ Export.
- Click on the patterns to be exported.
- Upon clicking the pattern, the Export window will open up, as shown below. Set the File Type to Amma (*.dxf) and press the Options button on the bottom.
- Check all the sections and press OK.
- When a window like the one shown below appears, press OK to continue.
- Ensure that there are no irregularities in the exported pattern, and press Close to complete the export.
Comments
Gerber is now updated to version 10....This is an old version
Hi
I imported Gerber V12 pattern according to the information above however a notch doesn't show. It comes out as a point.
I tried to open a rule table but it doesn't open. The message said file type not supported.
All points have been cut so I need to convert to a curve point.
Please let me know how to solve those issues.
Thanks