CLO HELP CENTER

How can we help you?

Internal Polygon/Line

Follow

Objective

Create Internal Polygons and Lines inside a Pattern.


Location

Main Menu ▶ 2D Pattern ▶ Create ▶ Internal Polygon/Line

2D Toolbar ▶  Internal Polygon/Line


Operation

  1. Follow the indicated guideline below: 

    Main Menu ▶ 2D Pattern ▶ Create ▶ Internal Polygon/Line

    2D Toolbar ▶  Internal Polygon/Line

  2. Click within a Pattern to establish the start point of an Internal Polygon/Line.

  3. Drag the mouse and click as needed to freehand the Internal Polygon/Line.

  4. To complete an Internal Polygon, click the start point.
    On the other hand, to complete an Internal Line, double click the last point.

※ Note: 

  • Right click inside a Pattern to open the Create Internal Polygon window and type in desired values.
    → An Internal Polygon is created with the designated values (ver2.5.0).

  • Click inside a Pattern to create the start point of an Internal Line. Then, drag and right click to open the Create Internal Polygon window. Enter desired values.
    → An Internal Line is created with the designated values (ver2.5.0).

  • Hold down the Ctrl key as creating an Internal Polygon/Line to create curves.

  • Hold down the Shift key to drag the mouse in straight lines or in 45º diagonal lines.
Was this article helpful?
3 out of 3 found this helpful

Comments

Please sign in to leave a comment.

  • Avatar
    rverma

    Is it possible to break the link and assign the internal line(s) to another pattern?

  • Avatar
    rverma

    Figured :) it's simple copy and paste. I was taking it too seriously. :)